FormulaFlash Supports BMW B48 B58 ECU Bench Unlocking

 

Formulaflash ecu programmer released a major software update V1.2.0.0 on August 19th, 2026.

Updated BMW MD1/MG1 ECU bench unlocking without opening ECU.

Bosch DDE8/DME8 B48 B58 ECUs now supported on bench mode.
Supported ECU models:
Bosch MD1CP032-TC299
Bosch MD1CS001-TC298
Bosch MG1CS024-TC298
Bosch MG1CS049-TC298
Bosch MG1CS201-TC298

Function:
Bench unlock
Read/write Flash + EEPROM
Checksum correction


FormulaFlash Update BMW MDG1 ECU Bench Unlocking
FormulaFlash Update BMW MDG1 ECU Bench Unlocking

Comments

Post a Comment

Popular posts from this blog

PCMTuner PCMFlash Module 42 Denso Bootloader Pinouts

Image
 Here come the PCMTuner PCMflash Module 42 Denso SH705x Bootloader pinouts by pcmtuner Marty. Module 42 ECU List: DIESEL CARS: MAZDA, MITSUBISHI, NISSAN, SUBARU SH705x 3 OPEL 1.7L CDTI SH7058/SH7059 OPEL 1.7L HYBRID SH7055 DIESEL TRUCKS SH7055/SH7058 DIESEL TRUCKS SH7058 ISUZU NPR (NQR) 5.2L DIESEL SH7058/SH7059 MAZDA PETROL SH7055/SH7058 SUBARU 22611-AG57X SH7055 SUBARU METAL CASE SH7055/SH7058 SUBARU PLASTIC CASE SH7058(S) SUBARU STELLA 2008 SH7058S SUBARU TCU SH7055/SH7058 SUZUKI JIMNY, LIANA SH7055 SUZUKI SH7055/SH7058 VOLVO 2.4L SH7058 JAGUAR X 2001–2008, S/XJ/XK 2003–2006 SH7055 DIESEL CARS: MAZDA, MITSUBISHI, NISSAN, SUBARU OPEL 1.7L CDTI SH7058/SH7059 OPEL 1.7L HYBRID SH7055 DIESEL TRUCKS SH7055/SH7058 DIESEL TRUCKS SH7058 ISUZU NPR (NQR) 5.2L DIESEL SH7058/SH7059 MAZDA PETROL SH7055/SH7058 SUBARU 22611-AG57X SH7055 SUBARU METAL CASE SH7055/SH7058 SUBARU PLASTIC CASE SH7058(S) SUBARU STELLA 2008 SH7058S SUBARU TCU SH7055/SH7058 SUZUKI J...
Read more

Foxflash Pinout to Mercedes SIEMENS VDO MSM2.0

Image
  Foxflash programmer will read and write Mercedes Benz gasoline SIEMENS VDO MSM2.0 ECU on bench. Here is the fox flash pinout to MSM 2.0. Select driver Mercedes Siemens ECUS 1.4/1.6 Siemends VDO MSM 2.0 FULL SYSTEM If old and new ecu have read flash and eeprom without problem. Write not work with foxflash. Have error. Cannot write any file as shown image below: After read flash/eprom — Disconnect ecu and restart software (unplug foxflash ) — restart Then connect again, Write flash, Also try lower power only need 13v on this ecu.
Read more