PCMtuner-tool

 In the latest software update of the CG FC200 ecu programmer, the J2534 function has been added. We are able to use the FC200 as a J2534 passthru device together with PCM-Flash software. Below, we demonstrate how to use the J2534 function of the FC200. ECU example: Geely Easy U2. Note: Like other J2534 devices, when the FC200 J2534 is used with PCM software, it can only be used in OBD mode. BENCH and BOOT modes are not available. Set up FC200 connection. Either connect FC200 via vehicle via OBD connector or set up an OBD on bench connection (using bench cable etc). It is very important to connect a 12V power supply to the FC200 unit. Activate FC200 J2534 switch. Run PCM software, select interface type as FC200-J2534 . Identify ECU information and read ECU. Read Geely Easy U2 ECU successfully.

 Mercedes Benz Bosch MED17.7.3.1 TC1797 ECU. CG FC200 read password ok, bench mode. Flex failed to read password. also bench mode. Flex is ok for this ECU. If it fails to read on bench, change power supply, use a 12v direct to a DC car battery. Flex also does VR obd, but if it is FBS4, bench only.

 Soultion for immo off for GREAT WALL WILGLE. ECU BOSCH 0281013328 EDC16C39–6.H1 MADE IN CHINA Great Wall EDC16C39–6.H1 IMMO OFF Tips Make immo off in eeprom only. eeprom only 95320. You can read eeprom with CG FC200 or other programmers. After writing in eeprom 95320, then jump tthe ecu PINS on the PCB as described here. Write IMMO OFF in 95320. Bridge the PINs as described on the picture. Remove the immobiliser box. Start the car. Follow the steps. www.iecutool.eu

  Question: Hi, Pcmtuner or FC-200? Which one is better? Here comes the table comparison: PCMTuner vs FC200 in ECU capabilities *Keep updating… Summary: FC200 has more protocol FC200 can only do checksum fix online, checksum won’t work if the subscription expires. FC-200 works only on Bosch ECUs, So for Magneti Marelli, Continental or siemens pcmtuner is better If you want to used for dpf,egr, adblue off and remap, PCMTuner is better FC200 only some BMW ECU can be done via OBD PCMTuner interface cannot do BMW ECUs (EDC17xx etc) In conclusion, depends on what is the main purpose of your buy. FC-200 could be useful for BMW ISN from Ecu or maybe for some Ecu cloning, but only some of them because most of MEDC17 needs adaption of OTP and password or immo transfer for successful cloning. If the main purpose is Chip tuning, PCMTuner is a better buy because it can calculate checksums and it is cheaper.