Flex Boot Glitch Solution for Peugeot 3008 MD1CS003

 Magic Motorsport Flex read and write Peugeot 3008 year 2021 Bosch MD1CS003 ECU successfully.

Unlock MD1CS003 locked ECU boot glitch mode.

Solder wires to the E-port directly without using the FLX 4.1 cable.

Then read and write ECU on bench after unlocking.

Works fine. Car starts without problem.

Images attached:


Flex Boot Glitch Unlock Peugeot 3008 MD1CS003 ECU
Flex Boot Glitch Unlock Peugeot 3008 MD1CS003 ECU
Flex Boot Glitch Unlock Peugeot 3008 MD1CS003 ECU
Flex Boot Glitch Unlock Peugeot 3008 MD1CS003 ECU
Flex Boot Glitch Unlock Peugeot 3008 MD1CS003 ECU
Flex Boot Glitch Unlock Peugeot 3008 MD1CS003 ECU


Comments

Post a Comment

Popular posts from this blog

Foxflash Pinout to Mercedes SIEMENS VDO MSM2.0

Image
  Foxflash programmer will read and write Mercedes Benz gasoline SIEMENS VDO MSM2.0 ECU on bench. Here is the fox flash pinout to MSM 2.0. Select driver Mercedes Siemens ECUS 1.4/1.6 Siemends VDO MSM 2.0 FULL SYSTEM If old and new ecu have read flash and eeprom without problem. Write not work with foxflash. Have error. Cannot write any file as shown image below: After read flash/eprom — Disconnect ecu and restart software (unplug foxflash ) — restart Then connect again, Write flash, Also try lower power only need 13v on this ecu.
Read more

PCMTuner Chevrolet SIM2K-D160 ECU Pinout

Image
 How to read a Chevrolet SIM2K-D160 ecu with pcmtuner ? Use this in Module 30, 1,3,5 — ECU ground (just connect one of the contacts) 77 — CAN-High 78 — CAN-Low 76 — K-Line 2 — +12V (ignition on) 4 — +12V (power supply of the main relay) 6 — +12V (non-switchable power supply) You may not be able to do this ECU in BSL 53 as main processor is MPC756MXP56 Second Processor TC1738. You could try OBD Module 30 Kia/Hyundai SIM2K 2.0L, 2.5L (SIM2K-D160) But failing that, you would have to do this in BSL mode 53 http://www.pcmtuner.org/pcmtuner-module-53-infineon-tricore-bsl-operation/
Read more