OBDSTAR DC706 Read/ Write 2014 Dodge Ram EDC17C79 ECU

 Although the OBDStar dc706 doesn’t show the Dodge Ram being supported it does work to read and write internal flash and eeprom.

The ram Pinout shows the can wires in a different place and only reads with Hp Tuners in the pinout it’s original hooked up in. However if you switch the can wires and add the gpt wires you’re able to use the OBDStar dc706 to read/ write these ecm’s and effectively clone them along with altering vin numbers.

You can see this pinout. Here got the CAN Wires positive, negative.

We all know the OBDSTAR supposedly will only read and write the Jeep.
There is no pinout for Dodge like we have on the HPTuner.

We’re just going to leave this pinout. Then hook up our OBDSTAR DC706 ecu programmer.

We have this hooked up same ECM. We switched our CAN wires to a different pin.

We’re using this exact pinout right there.
We’ve switched an alltime positive to an ignition there.

You can read the internal Flash and you can write both of those.
If you want to start cloning the ECMs, you can do it underneath the Jeep.

You can also find the VIN number.

www.iecutool.eu