PCMtuner-tool

  FormulaFlash ECU TCU programming tool released new software V1.0.0.5 on Aug. 1st, 2024. Add the following ECUs: 1. Added all brands of Bosch ME7.8.8 engine OBD virtual reading, writing, imm off, power upgrade, idle speed adjustment functions (both OBD& bench are supported); 2.Added BOOT mode reading and writing FLASH and EEPROM and cloning functions for all brands of Delphi DCM7.1AP; 3. Added the function of reading and writing FLASH and EEPROM in SIMOS8.5 BENCH mode of Volkswagen and Porsche; 4. Added the function of reading and writing FLASH and EEPROM in SIMOS8.6 BENCH mode; 5 Added the function of reading and writing FLASH and EEPROM in SIMOS18.X Boot mode; 6 Added EDC17 series Checksum [Optimization] Optimize the problem of writing failure in some ECUs of Bosch MEDC17 engine. www.iecutool.eu

 Here comes the user report: OBDSTAR X300 Classic G3 Clone Ford Transit 2011 BCM successfully. Need to activate ECU/TCU flasher license to the G3. You can do cloning with DC706 as well. Go to Body Module, quick search Ford BCM SIEMENS 0L01Y (9S12DT256) Choose Bench mode with P004 adapter. Check wiring diagram. Connect BCM module with G3 and P004 adapter. Connect ECU. Read INT eeprom. Read INT flash. Write INT eeprom. Write INT flash. Disconnect. Cloning BCM successfully. www.iecutool.eu

  Xhorse Multi Prog read and write Nissan Bosch EDC16C41 ECU on bench successfully. It is a NISSAN W41 bus. ECU: BOSCH EDC16C41 Read bench ok. Write bench ok. Checksum by multi prog. DPF REMOVED. www.iecutool.eu

  Foxflash new user feedback: Opel Meriva 1.7DTi DELCO E4 OBD read ID- OK. READ ECU via OBD OK WIRITE ECU via OK CHECKSUM- failed. Foxflash failed to correct checksum via OBD, manually correct checksum with L-suite. www.iecutool.eu

 It is a Fiat Ducato year 2011 2.3L 16V with MJD 8F3 ECU. Foxflash reads and writes this ECU via full system successfully. MJD8F IAW MUJET Full system Read ok . Write ok. Checksum by foxflash. FULL SYSTEM DPF + EGR OFF. You can also do it via OBD, but OBD takes too much time. Always do pinout.

  Foxflash new user feedback: Ford Ecoboost MED17. 2 ECU Ecu was brought in by battery short. Read on bench ok Write on bench ok Checksum by foxflash. Another successful rebuild. Ecu tests and verifies. Success. BOSCH MED17.2 [ 1767 ] — Ford [Gasoline] bench pinout To read and write use the following driver: → BENCH TRICORE → FORD → TC1767 — FORD → MED17.2 www.iecutool.eu

 Will Alientech KESS3 read/write Scania EMS S8 / EMD1 ec? Is it possible do via OBD or need bench? For example 2018 Scania R450 EU6 Yes, People have done a lot of them without problem. Flash in obd with id only or real reading in harness then writing by harness or by obd. only S10 coming soon. S6/7/8 is available and emd1 works with s8 protocol. Works perfectly by obd. 100% tested by us on several engines.