PCMtuner-tool

  Foxflash read and write Citroen ME7.4.4 ECU successfully. Mode: Citroen Saxo VTS 120 HP ECU & protocol: ME7.4.4 Full system Read: 2 min Write: 3 min No checksum. Car start. Immo Off in EEPROM and FLASH. Images attached:  

  Question 1: When I import a file to write in Dimsport The Genius programmer it doesn’t put it in the write folder? How to find the imported files in The Genius? Answer: If you use Race EVO to edit it, the file goes into Bench or Obd, if you use another software it’s all in Generic. You have to choose " no info — generic ". It’s your file extension that is not correct compared to what the software detects. Question 2: I need information about race evo program users. How to fix header on mod file? Answer: No need header on mod file, edit noheader file, export and send to the genius. "Folder" OBD , OPEN, BENCH have inside only file with header. All other type dile (without header) are in unkown "Folder" . Only setting File are able to generate/modify corretly header information . If file arrive inside setting file wih header, and modify file with setting file , then mod file will be inside thegenius in correct "folder" . OBD , OPE...

 In the latest software update of the CG FC200 ecu programmer, the J2534 function has been added. We are able to use the FC200 as a J2534 passthru device together with PCM-Flash software. Below, we demonstrate how to use the J2534 function of the FC200. ECU example: Geely Easy U2. Note: Like other J2534 devices, when the FC200 J2534 is used with PCM software, it can only be used in OBD mode. BENCH and BOOT modes are not available. Set up FC200 connection. Either connect FC200 via vehicle via OBD connector or set up an OBD on bench connection (using bench cable etc). It is very important to connect a 12V power supply to the FC200 unit. Activate FC200 J2534 switch. Run PCM software, select interface type as FC200-J2534 . Identify ECU information and read ECU. Read Geely Easy U2 ECU successfully.