PCMtuner-tool

 Although the OBDStar dc706 doesn’t show the Dodge Ram being supported it does work to read and write internal flash and eeprom. The ram Pinout shows the can wires in a different place and only reads with Hp Tuners in the pinout it’s original hooked up in. However if you switch the can wires and add the gpt wires you’re able to use the OBDStar dc706 to read/ write these ecm’s and effectively clone them along with altering vin numbers. You can see this pinout. Here got the CAN Wires positive, negative. We all know the OBDSTAR supposedly will only read and write the Jeep. There is no pinout for Dodge like we have on the HPTuner. We’re just going to leave this pinout. Then hook up our OBDSTAR DC706 ecu programmer . We have this hooked up same ECM. We switched our CAN wires to a different pin. We’re using this exact pinout right there. We’ve switched an alltime positive to an ignition there. You can read the internal Flash and you can write both of those. If you wan...

 Reading BMW Bosch EDC17C50 ECU with foxflash on bench. But it kept stopping at 44% when writing file on bench using clone function (Built-in function). Opened it and worked right away in boot mode. All ok. Cloned ecu successfully. Password BFT read. 15 minutes write. When you clone the Bosch ECU you have to look at what it says EEPROM PROTECT, then bench blocks the ECU, it has to be because of boot.

 How to read Audi Q8 MD1CP001 ECU using Launch x-prog3 PC adapter ? It is a easy task with Launch x-prog3. Run X-PROG3 PC software, select Audi- Q8 2018–2019- MDCP004 SPC5777. Check wiring diagram The connection is easy. Connect ECU with x-prog3 and PC adapter . Connect with ECU. Then read/save eeprom and flash data respectively. X-prog3 also corrects checksum for MD1 ECU. www.iecutool.eu