PCMtuner-tool

 User report: CG FC200 read and write Ford Ecosports 2020 ecm successfully. select Bosch EDC17C70 TC1793 Check wiring diagram Read ID ok Read dflash and pflash ok Write dflash and pflash ok. checksum by FC200. www.iecutool.eu

  Foxflash read Volkswagen Lupo 1,4 16v gasoline ECU successfully. It is a Marelli IAW 4MV ECU. Read on bench ok. Badly soldered but works. eeprom ok. Select VW->Lupo ->Marelli IAW 4MV Not possible to read via OBD.

 What is the difference between CG FC200 and CG100X programmers? They are different programmers. FC200 : used to read, write and clone engine ECU and transmission gearbox TCUs . FC-200 could be useful for BMW ISN from Ecu or maybe for some Ecu cloning. FC-200 supports most bosch ecus but has more pinout diagram for every ECU it supports and more user friendly, CG100X: CG100X is the upgrade version of CG100 Prog III. CG100X adds more airbag, eeprom and mileage correction models. CG100X Programmer also can do VW MQB dashboard mileage correction while FC200 cannot. FC200 does not have airbag or mileage capacities. www.iecutool.eu

  Problem: My CG FC200 programmer shows the device activation time remains 26 days. But software subscription is still active. Solution: FC200 will activate (renew) every 30 days. When it counts to 0, it will automatically renew for another 30 days (MUST enable network connection to activate fc200 again).

  Problem: I tried to clone an ECU with CG FC200 programmer, but it asks for an authorization code, where to get this code? Solution: Users are required to connect network to access FC200 server to get the authorization code for checksum correction when doing ECU cloning.

  Problem: I tried to read Alfa Romeo M10JA ecu via car OBD and foxflash failed to read. Solution: If failed to read M10JA ECU via OBD, read it in boot mode. MARELLI 10JA — FCA, Alfa Romeo boot pin (BAM connection) to foxflash To read and write use the following driver: ->TOOL BOOT ->TOOLS BOOT MODE ->Motorola Freescale BAM ->Freescale SPC5777C www.iecutool.eu

 Volvo xc70 mk2 2.4t with b5244t3 engine, bosch me 7.0 ecu, foxflash read and write this ECU successfully in boot mode. BOSCH ME7.0 [ C167 ] — Volvo [ Gasoline ] boot pinout to foxflash To read and write use the following driver: → TOOLS BOOT MODE → SIEMENS-INFINEON C167 → Bosch — Flash 29F800 Attention: If the ECU doesn’t enter boot mode, proceed as follows: → Switch off the ECU and remove the grey wire. → Connect directly to ground the boot pin with a needle. → Switch on the ECU. → Remove the ground. → Launch the driver and click the read / write buttons. Had problems with the car when i got it for the first time. Was misfiring and overboosting, got fault codes from turbo boost controller etc. It wasn’t working really good. Today i tried flashing it with stage 2 software for fun and all the problems were gone, and has lot of power now, it just had bad software inside all the time. The foxflash software says xc90 but it is working good in my car and i didnt need