PCMtuner-tool

 It is a Ford Transit Visteon with DCU101 ECU. Foxflash will read and write this ECU via OBD. It is DCU 101 but protocol DCU 102/108 works. Select OBD drive ->Ford ->Transit ->2.2/2.4 TDCI E4 FOMOCO VISTEON DCU 102/108 *CAN Read ok via OBD. Write OK via OBD. Checksum by foxflash. EGR + DPF OFF. www.iecutool.eu

  FormulaFlash released new software 1.0.0.7 on October 21st, 2024. 1. Adds ME788 BSL mode, read, write, clone, checksum and IMMO Off, idle speed adjustment, power upgrade (World’s first) 2. New checksum: Simos 8.x, MSD80, MSD81, MSD85, MSD87 Upcoming updates: 1. ME7.8, ME797, ME7971 virtual reading and writing, checksum, one-click operation mode for immo off, idle speed adjustment, power upgrade (World’s first) 2. ME797, ME7971 BSL read, write, clone and checksum 3. EDC16, EDC17, MED9 DTC clean and idle speed adjustment solution www.iecutool.eu

  Problem: Successfully read and write Audi Bosch Md1cs004 ECU with Foxflash . SCR off. But scanner shows fault code U2A200 after scr off. Reductant quality sensor no communication. How to fix it? Solution: Just disconnect adblue pump. Disconnect adblue if the fault doesn’t disappear do dtc off solution as well. User feedback: Unplugged Scr unit. Dtc gone. But new in gateway instead for scr.. coded scr out with autel in gateway. Now no issue. www.iecutool.eu

 It is a Yamaha MT 07 2021 with R5F10DMFJ chip. How to read/write this massive chip? What tool can be used? Here is the clue. UPA 1.3 cannot read, you need pogrammer for this mcu smok, xtool, carprotool, CG100/ CG100X , vvdi prog ect Here is the pinout wiring connection. Feedback: I finally bought a CG100x from iecutool.ru . I’ve just made on the soldering points. successfully calculate km to 5000. Thanks so much for your help.

 Landrover Freelander2 CEM successfully cloned by OBDSTAR DC706 programmer. Delphi CEM M30882F+ 95320 DC706 clone this CEM on bench mode using P004 adapter. Read EXT eeprom 95320 Read EXI eeprom decrypted Read INT flash M30882F Read configuration zone Write EXT eeprom 95320 Write EXI eeprom decrypted Write INT flash M30882F Write configuration zone Car starts no problem. www.iecutool.eu

  Problem: Foxflash read and write Audi MED9.1 via OBD successfully. But after flash and 5 or 6 starts, unable to start. Any solution? Possible reason: Checksum problem. Solution: Modify checksum manually. FYI: Better do it on bench mode cause this ECU is not easy to find. Bench mode is safer. check pinout here http://www.pcmtuner.org/foxflash-read-vw-med9-1-ecu-on-bench/ User feedback: Bad checksum, modified checksum with winols and work perfectly. www.iecutool.eu

 Read and write Bosch ME9.7 by Alientech KESS3 successfully. It is a Mercedes S500 V221 with Bosch ME9.7 ECU. Function: Identify ECU Clone ECU Read backup Write backup Reading Micro, Flash and Eeprom Writing Micro, Flash and Eeprom