PCMtuner-tool

 OBD reading the BMW ZF 8 HP gearbox with Foxflash ecu programmer , nbt id4 carplay bonus and sport display modification stage 2. It works ! Connect foxflash via OBD. Select menu TCU Gear BMW Gear-> 4 Series (F32-F33-F36)->ZF 8HP *CAN. Get ID OK Read data OK Modify data by tuner.

  Fetrotech Black standalone read and write Med9.1 MPC562. Read very fast. I've tried on two ecu and everything is fast. read fast and pinout is good. Checksum its ok for that ecu. Wrote succeed. check bench pinout in tuner-box.com Read and write no problem.

  Problem: I tried to read CONTINENTAL EMS 3132 Renault with pcmtuner module 38 via OBD, but shows an identification failure. Any idea? Solution: Some succeeded reading Renault EMS 3132 with pcm tuner. But between any identification you must disconnect pcmtuner. Disconnect from OBD port and switch of ignition, restart pcmtuner flash, and plug in obd and put ignition back on. If failed to read it by OBD, you can try module 53 BSL mode. Ktag is good on Renault ems 3132 in boot mode. Foxflash will read it on bench bench pinout also boot mode. SIEMENS EMS 3132 [C167] — Renault [ Gasoline ] boot pinout

 How to read/write a Delphi DCM3.7AP ecu with foxflash ecu programmer ? Foxflash will read Cheverolet, GM and Opel Delphi DCM3.7AP MPC55xx ecus. Delphi DCM3.7AP Jtag MPC55xx pinout to Foxflash Delphi DCM3.7AP MPC55xx Solder the rainbow flat cable on the pcb: To read and write use the following driver: ->BDM/Jtag ->BDM/Jtag Mode ->Jtag Nexus MPC/SPC ->MPC 55xx

  PCMTuner Module 69 Mercedes MED 17.1.1 1.Read DTC Complete 2.Identification Complete But I can not read like photo, (Failure , file not found try again later) Error codes 404,13,0 I did same ecu 2pcs but the same error. I check sereval times pin connector, that is all right, help me please. Solution: Mercedes module is OBD not bench, you need 71 to read med/edc17 on bench. module 71 for bench or 53 for boot. Mercedes ME17.1.1 bench pinout to pcmtuner

  Question: I have this problem when launching pcmtuner software . I reinstall windows and have a problem installing pcm, (downloading microsoft edge webview2 and after download installer says not work for my system. Only win10). Installation stop. Solution: First error means you system has malware and viruses which have infected your files. Please install on a clean computer! try to use win10 or win7 with 64bit. Feedback: Problem solved after installing manually microsoft edge.

  Problem: I need to read Alfa Romeo Giulietta with EDC17C69 control unit with pcmtuner . When I read both Eeprom and microprocessor, it makes me write the Eeprom but does not write the micro. if I write the Eeprom with the same file that I have read, everything is ok. If I write the chip with the same file that I read, it gives me the message of the photo. Any idea? Solution: You are trying to write the file in the eeprom. Need to Change to flash. You need to select Flash in drop down box to write flash! you cannot write flash if eprom is selected. Select flash in the drop-down menu and flash your file, not flash in eeprom.